Автор: Andrzej Baczynski,Zbigniew Kasprzycki
Год: 1986
Издатели: Dyrekcja Szkolenia Ekonomicznego PTE
Языки:
Польский
Формат:
TZX лента
Требования:
ZX Spectrum 48K
Ссылки:
Страница на ZXArt
Страница на World Of Spectrum
Страница на Spectrum Computing
Скриншоты:
Год: 1986
Издатели: Dyrekcja Szkolenia Ekonomicznego PTE
Языки:
ПольскийФормат:
TZX лентаТребования:
ZX Spectrum 48KСсылки:
Страница на ZXArt Страница на World Of Spectrum Страница на Spectrum ComputingСкриншоты:
This package contains a LOGO interpreter with a bunch of
example programs written for educational purposes.
----------------
To load a LOGO program load the interpreter first and do
the following steps:
- position the tape at correct place
- execute: ³aduj "name, for example: ³aduj "zad1
- start the tape (if it didn't start itself already).
To type the Polish letter ³ press SHIFT+9 to change the mode and then l.
When you press SHIFT+9 the letter l in bottom right corner will
become inversed as an indicator of Polish letters mode.
A LOGO program will load them. It'll contain several procedures which
names will be displayed.
----------------
To display procedure code:
Execute: red "name
----------------
To run the program:
To execute a procedure just type its name. There is always a main
procedure, called usually "test", so to execute the whole program
just type :test+ENTER.
example programs written for educational purposes.
----------------
To load a LOGO program load the interpreter first and do
the following steps:
- position the tape at correct place
- execute: ³aduj "name, for example: ³aduj "zad1
- start the tape (if it didn't start itself already).
To type the Polish letter ³ press SHIFT+9 to change the mode and then l.
When you press SHIFT+9 the letter l in bottom right corner will
become inversed as an indicator of Polish letters mode.
A LOGO program will load them. It'll contain several procedures which
names will be displayed.
----------------
To display procedure code:
Execute: red "name
----------------
To run the program:
To execute a procedure just type its name. There is always a main
procedure, called usually "test", so to execute the whole program
just type :test+ENTER.